Page 1 of 1

PKE HOLDER

Posted: October 2nd, 2022, 2:54 pm
by Cenzor
Anyone have links for a good PKE meter holder for belt and/or radio on amazon or smthing?

Re: PKE HOLDER

Posted: October 2nd, 2022, 7:49 pm
by mardin_chatzuk
This post may contain an affiliate link that helps support GBFans.com when you make a purchase at no additional cost to you.

I use a leather tape-measure holster similar to this one: https://www.amazon.com/Basket-Leather-M ... 07MSFP2VZ/

Just remove the strap that would secure the tape measure, and stick the PKE meter's handle through the opening at the bottom. Can't say whether this exact one would fit well (you should check its dimensions and measure your meter to compare), but the one I have fits the Matty PKE quite well.

Re: PKE HOLDER

Posted: October 27th, 2022, 8:32 am
by Beelzebot
This post may contain an affiliate link that helps support GBFans.com when you make a purchase at no additional cost to you.

I used a grenade pouch I found at the local army surplus store. Like the one in the link below. I cut off the flap, cut a larger hole in the bottom and painted it black. The pouch was under $10 locally.

https://www.ebay.com/itm/234527173433?h ... R4aW1p2DYQ

Re: PKE HOLDER

Posted: November 3rd, 2022, 9:39 pm
by gman666
This post may contain an affiliate link that helps support GBFans.com when you make a purchase at no additional cost to you.

I used the tape measurement holder also and removed the strap. I had to open the hole up in the bottom to get the square PKE meter handle thru. You also have to dye them black but I had the black dye for this and the ghost trap/gizmo holsters.
https://www.amazon.com/dp/B0006GPZ7Q?ps ... ct_details

Thanks!

Greg

Re: PKE HOLDER

Posted: November 4th, 2022, 9:33 am
by Holydohnut
I made my own!

Image
Image
Image

The leather offcuts came from ebay and the "studs" from amazon. Happy to post the dimensions if it helps?

Re: PKE HOLDER

Posted: November 21st, 2022, 5:16 pm
by WShawn
I made mine from scratch using some scrap leather from Tandy's. I wanted to match the aesthetic of the belt gizmo. It was a fun little project, not too hard.

https://shawnmarshallmakes.com/pke-holster/

Image

Re: PKE HOLDER

Posted: August 1st, 2023, 4:45 pm
by Corbidorbidoodle
This post may contain an affiliate link that helps support GBFans.com when you make a purchase at no additional cost to you.

I use a Husky tape measure holder from Home Depot. It's almost perfect and was like, $8. I had to use a razor blade to cut a bigger hole in the bottom for the meter to sit in, and I peeled off the Husky logo and added a little caution striping. You can see the yellow electrical tape I wrapped the handle with on my belt there.

Image
Image