Have a guide or tutorial? Post it up!
#4916865
On the powercell/pack light board there is a blue block with two set screws. It is marked as "Pos" and "Gnd." You would need a stretch of wiring with bare ends on one side and preferably an adapter to connect to the blue brick otherwise you would have to cut off the male end of the battery. Not sure coming off the battery which wire would constitute the positive or the ground though. I am using a Spengler plate with wires (courtesy of NStevic01) to connect the brick to my Matty Blaster soundboard but the bare-wire hookup would be similar. http://www.gbfans.com/forum/viewtopic.php?f=31&t=35806

    Has anyone successfully transferred the pedal el[…]

    I have not heard of this. On the Matty PKE, if the[…]

    Hard to tell if it’s an actual black fligh[…]

    Positron Props GB1 Pack Build

    Awesome!! Good luck on your build! Tom's shell i[…]