User avatar
By l3w1sb159
#4965027
I've looked at various plans but I haven't been able to find any measurements for how far the cartridge overhangs past the main body of the trap. As I'm building a Benofkent kit, the cartridge sits flush with the front of the body. I've seen tobycj use a sheet of styrene on the back of his cartridge to space it properly, but I wanted to check what was the right measurement to be going for.
By tobycj
#4965063
I just eyeballed mine as I couldn't find any measurements myself. For reference, it was 4mm styrene if I didn't mention that in my build thread, plus I had a connector that added a couple of mm too.
User avatar
By l3w1sb159
#4965066
Ah right, I tried to eyeball mine against various pics and it looked the right distance with about 13mm gap behind the cartridge? As I'm planning on bolting the cartridge in, I won't have a connector to add space.

Just wanted to get some second opinions before I committed.
    The journey from commonplace to Ecto-75.

    Whole car is great but the pack trolly...how?

    Proton Props???

    If anyone here is still pondering ordering from th[…]

    I haven't done the new update to the Spirits Unlea[…]

    I ended up grabbing one of the 84 wands just t[…]