#4969369
So 15 mins after receiving my wand light kit i set it all up on the table and hook two 12v wires to the driver board, one to the positive terminal and one to the ground. Then i hook the ground wire to the negative post on a 9v battery, the positive wire i leave loose cuz its just a quick test to see of it will turn on and it does! The positive wire then slips off the terminal and touches both the positive and negative terminals at the same time and i hear a zap and the driver board is dead:( so now im just wondering what would have fried first and if i could maybe replace it before resorting to purchasing another board. any help would be great

    Hey and welcome

    My Little Pony/Ghostbusters crossover done by my d[…]

    Great work identifying the RS Temperature Control […]

    I read Back in Town #1. Spoilers : Hate to b[…]