- August 27th, 2019, 10:55 am#4923339
Hey guys, so back in 2017 when I started working on the pack that I finally finished (I actually started 3D printing parts and then shelved the project a while back), I had made a wand/thrower/gun and put the GB fans light kit in there. There was a few design flaws that I hated and I ended up deciding the scrap that wand because there was no room at all for the GBFans kit inside without carving out space and I knew that I wanted the rumble motor and all in there. So I basically salvaged the light kit from that proton gun to go into my new one. Everything is working perfectly except for the SLO-BLO light and I can not for the life of me figure out why. I even checked the soldering points on its wires and they seem to be fine, I don't get it.